M-Audio Trigger Finger Pro User Manual page 49

MIDI Channel and Output
The MIDI settings determine over which MIDI channel each control sends its messages and
whether the messages are sent over Trigger Finger Pro's USB Port, MIDI Out jack, or both.
To change a control's MIDI channel and output configuration:
1. Enter Control Mode by pressing the Control Mode Button (Ctrl).
2. Press the second Function Button (Edit Controls). The display will tell you to move the
desired control.
3. Press the Control Bank button to select the desired bank.
Move the Assignable Control you want to edit (move a fader or knob, or press a button),
or use the Value Dial to select it. The control type and number will appear in the upper
right corner of the display. When you have selected the desired control, press the third
Function Button (Edit Control).
4. Press the third Function Button (More).
5. Turn the fourth Assignable Knob (MIDI-Ch) to set the MIDI channel over which the
control will send its messages (01–16 or UsePrefs).
Press the first Function Button (Output) to cycle through the available MIDI output
configurations the control can send its messages (USB+Jack, USB, Jack, or UsePrefs).
(Jack refers to Trigger Finger Pro's MIDI Out jack.)
For either setting, when UsePrefs is selected, the control will use whatever settings are in
Trigger Finger Pro's Preferences. See the Preferences: MIDI chapter to learn more
about this.
6. Make other changes in Control Mode, or exit Control Mode by pressing the Control
Mode Button (Ctrl) or the fourth Function Button (Exit) three times.
49
