Bars - M-Audio Trigger Finger Pro User Manual

Bars

You can create Sequences with a total length of one to four bars.
To set/change the number of bars in a Sequence:
1. Enter Sequence Mode by pressing the Sequence Mode (Seq) button.
2. Check above the third Function Button (Page) to make sure you are viewing Page 1. If
you are on Page 2, press the button to move to Page 1.
3. Check above the first Function Button (Bars) to see the Sequence's current bar length.
The default bar length of a blank Sequence is 4 bars. To change it, press the button to
cycle through the options (1, 2, 3, or 4 bars).
Important:
If you increase the number of bars, the new bars will be added to the end of the
Sequence.
If you decrease the number of bars and the "removed" bars contained steps, those bars
will not be played when you play the Sequence but still retain their steps. This means you
can increase the bar length again without having lost the steps in those bars.
Furthermore, this means you can still view and edit bars "beyond" the limit of the Bars
setting (see the following page to learn more about this).
4. Exit Sequence Mode by pressing the Sequence Mode (Seq) button or fourth Function
Button (Exit).
SEQUENCER
TEMPO: SWING:
120 50%
01: Sequence BANK:A
GATE FIX VEL:
50% 127
BAR:01 PAD:A01
BARS: EDIT PAGE:
02 VELOCITY 1 of 2
67
CHANGE->
SEQUENCE
EXIT