M-Audio Trigger Finger Pro User Manual page 42

Message
The Message determines what kind of MIDI message each assignable control sends out.
Additional settings are associated with each Message.
To change an assignable control's message:
1. Enter Control Mode by pressing the Control Mode Button (Ctrl).
2. Press the second Function Button (Edit Controls). The display will tell you to move the
desired control.
3. Press the Control Bank button to select the desired bank.
Move the Assignable Control you want to edit (move a fader or knob, or press a button),
or use the Value Dial to select it. The control type and number will appear in the upper
right corner of the display. When you have selected the desired control, press the third
Function Button (Edit Control).
4. Press the first Function Button (Message) to cycle through the available options:
•
Control Change (CC): Use the first Assignable Knob (CC) to set the CC number
that the control will send (00–127).
•
Non-Registered Parameter Number (NRPN): Use the first Assignable Knob
(MSB) and second Assignable Knob (LSB) to set the MSB (Most Significant Byte)
and LSB (Least Significant Byte) that the control will send (00–127).
•
Program Change (Prog Ch) (Assignable Buttons only): Use the third Assignable
Knob (Prog) to select the Program Change number that the control will send (00–
127). Use the first Assignable Knob (MSB) and second Assignable Knob (LSB) to
set the MSB (Most Significant Byte) and LSB (Least Significant Byte) that the control
will send (00–127).
5. Make other changes in Control Mode by pressing the second Function Button (Edit
Controls), or exit Control Mode by pressing the Control Mode Button (Ctrl) or the fourth
Function Button (Exit) twice.
42
