M-Audio Trigger Finger Pro User Manual page 47

Type
(Assignable Buttons only)
The Type determines how the Assignable Buttons function when pressed. Additional settings
are associated with each Type.
To change a button's type:
1. Enter Control Mode by pressing the Control Mode Button (Ctrl).
2. Press the second Function Button (Edit Controls). The display will tell you to move the
desired control.
3. Press the Control Bank button to select the desired bank.
Move the Assignable Control you want to edit (press a button), or use the Value Dial to
select it. The control type and number will appear in the upper right corner of the display.
When you have selected the desired control, press the third Function Button (Edit
Control).
4. Press the second Function Button (Type) to cycle through the available options:
•
Momentary: The button will be on for as long as you are holding the button down.
When you release it, it will turn off. Use the third Assignable Knob (Press) and
fourth Assignable Knob (Release) to set the values that the control will send (00–
127) when pressed and released.
•
Toggle: Each time you press the button, it will turn on or off and remain in that state
until you press it again. Use the third Assignable Knob (On) and fourth Assignable
Knob (Off) to set the values that the control will send (00–127) when turned on and
off.
•
Single: Each time you press the button, it will send its CC value once. Use the third
Assignable Knob (Value) to set the value that the control will send (00–127) when
pressed.
Tip: See the Colors section on the previous page to learn how to set the "on" and "off"
colors for the buttons.
5. Make other changes in Control Mode, or exit Control Mode by pressing the Control
Mode Button (Ctrl) or the fourth Function Button (Exit) three times.
47
