The IP-MAC Binding commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
create address_binding ip_mac ipaddress
config address_binding ip_mac ipaddress
config address_binding ip_mac ports
show address_binding
delete address_binding
enable address_binding trap_log
disable address_binding trap_log
Each command is listed, in detail, in the following sections.
create address_binding ip_mac ipaddress
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create an IP-MAC address binding entry on the Switch:
DES-3026:4#create address_binding ip_mac ipaddress 10.1.1.3
mac_address 00-00-00-00-00-04
Command: create address_binding ip_mac ipaddress 10.1.1.3
mac_address 00-00-00-00-00-04
Success.
DES-3026:4#
DES-3000 Series Layer 2 Switch CLI Reference Manual
Parameters
<ipaddr> mac_address <macaddr> {ports [<portlist> | all]}
<ipaddr> mac_address <macaddr> {ports [<portlist> | all]}
[<portlist> | all] state [enable | disable] allow_zeroip [enable |
disable]
[ip_mac {all | ipaddress <ipaddr> mac_address <macaddr>} |
blocked {all | vlan_name <vlan_name> mac_address
<macaddr>} | ports]
[ip-mac [ipaddress <ipaddr> {mac_address <macaddr>} | all] |
blocked [all | vlan_name <vlan_name> mac_address
<macaddr>]]
Used to create an IP-MAC address binding entry.
create address_binding ip_mac ipaddress <ipaddr> mac_address
<macaddr> {ports [<portlist> | all]}
This command will create an IP-MAC address binding entry.
<ipaddr> - The IP address of the device to be bound to the MAC address
stated below.
mac_address <macaddr> - The MAC address of the device to be bound
to the IP address stated above.
ports [<portlist> | all] – The port or ports bound to the IP address and
MAC address stated above.
Only administrator-level users can issue this command.
IP-MAC B
115
20
C
INDING
OMMANDS