Commands - D-Link DES-3010F Command Line Interface Manual

The DES-3000 switch series implements the server-side of the IEEE 802.1x Port-based and MAC-based Network Access Control.
This mechanism is intended to allow only authorized users, or other network devices, access to network resources by establishing
criteria for each port on the Switch that a user or network device must meet before allowing that port to forward or receive
frames.
Command
enable 802.1x
disable 802.1x
config 802.1x auth_mode
show 802.1x auth_state
show 802.1x auth_configuration
config 802.1x capability
config 802.1x auth_parameter ports
config 802.1x auth_protocol
config 802.1x init
config 802.1x reauth
config radius add
config radius delete
config radius
show radius
create 802.1x user
delete 802.1x user
show 802.1x user
show acct_client
show auth_client
show auth_diagnostics
show auth_session_statistics
show auth_statistics
create 802.1x guest_vlan
config 802.1x guest_vlan ports
delete 802.1x guest_vlan
show 802.1x guest_vlan
DES-3000 Series Layer 2 Switch CLI Reference Manual
Parameters
[port_based | mac_based]
{ports <portlist>}
{ports <portlist>}
ports [<portlist> | all] [authenticator | none]
[<portlist> | all] [default | {direction [both | in] | port_control [force_unauth |
auto | force_auth] | quiet_period <sec 0-65535> | tx_period <sec 1-
65535> | supp_timeout <sec 1-65535> | server_timeout <sec 1-65535> |
max_req <value 1-10> | reauth_period <sec 1-65535> | enable_reauth
[enable | disable]}]
[local | radius_eap]
[port_based ports [<portlist> | all] | mac_based [ports] [<portlist> | all]
{mac_address <macaddr>}]
[port_based ports [<portlist> | all] [<portlist> | all] {mac_address
<macaddr>}]
<server_index 1-3> <server_ip> key <passwd 32> [default {auth_port
<udp_port_number 1-65535> | acct_port <udp_port_number 1-65535>}]
<server_index 1-3>
<server_index 1-3> <server_ip> key <passwd 32> [default | {auth_port
<udp_port_number 1-65535> | acct_port <udp_port_number 1-65535>]}
<username 15>
<username 15> {force_agree}
{ports [<portlist> | all]}
{ports [<portlist> | all]}
{ports [<portlist> | all]}
<vlan_name 32>
[<portlist> | all] state [enable | disable]
<vlan_name 32>
802.1X C
142
25
OMMANDS