D-Link Xstack DGS-3300 Series User Manual page 134

xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch User Manual
The page shown below is the IP CPU Access Profile Configuration page.
Parameter Description
Profile ID (1-5)
Type
VLAN
Source IP Mask
Destination IP Mask
DSCP
Protocol
Figure 6- 77. CPU Access Profile Configuration window- IP
Type in a unique identifier number for this profile set. This value can be set from 1 - 5.
Select profile based on Ethernet (MAC Address), IP address, packet content mask or
IPv6. This will change the menu according to the requirements for the type of profile.
Select Ethernet to instruct the Switch to examine the layer 2 part of each
•
packet header.
Select IP to instruct the Switch to examine the IP address in each frame's
•
header.
Select Packet Content Mask to specify a mask to hide the content of the
•
packet header.
IPv6 instructs the Switch to examine the IPv6 part of each packet header.
•
Selecting this option instructs the Switch to examine the VLAN part of each packet
header and use this as the, or part of the criterion for forwarding.
Enter an IP address mask for the source IP address.
Enter an IP address mask for the destination IP address.
Selecting this option instructs the Switch to examine the DiffServ Code part of each
packet header and use this as the, or part of the criterion for forwarding.
Selecting this option instructs the Switch to examine the protocol type value in each
frame's header. Then the user must specify what protocol(s) to include according to
the following guidelines:
Select ICMP to instruct the Switch to examine the Internet Control Message Protocol
(ICMP) field in each frame's header.
Select Type to further specify that the access profile will apply an ICMP type
•
119