Table of Contents
Advertisement
xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch User Manual
the switch in the switch stack into this field. When a range of ports is to be configured, the
Auto Assign check box MUST be clicked in the Access ID field of this window. If not, the
user will be presented with an error message and the access rule will not be configured.
The port list is specified by listing the lowest switch number and the beginning port
number on that switch, separated by a colon. Then the highest switch number, and the
highest port number of the range (also separated by a colon) are specified. The beginning
and end of the port list range are separated by a dash. For example, 1:3 specifies switch
number 1, port 3. 2:4 specifies switch number 2, port 4. 1:3 - 2:4 specifies all of the ports
between switch 1, port 3 and switch 2, port 4 − in numerical order. Entering all will denote
all ports on the Switch.
To view the settings of a previously correctly configured rule, click
screen:
In the Configuration folder, click the Access Profile Table link opening the Access Profile Table. Under the heading
Access Rule, clicking Modify, will open the following window.
To create a new rule set for an access profile click the Add button. A new window is displayed. To remove a previously
created rule, click the corresponding
Figure 6- 65. Access Rule Display window (Ethernet)
NOTE: When using the ACL Mirror function, ensure that the Port Mirroring
function is enabled and a target mirror port is set.
Figure 6- 66. Access Rule Table window – IP
button.
in the Access Rule Table to view the following
108
Advertisement
Table of Contents
