Converting To Desktop Configuration (Z400 Only) - HP Z Workstation series User Manual

Hide thumbs Also See for Z Workstation series:

Table of Contents

Converting to desktop configuration (Z400 only)

This workstation can be operated in the mini-tower or the desktop configuration. Follow these steps to

convert to desktop configuration operation:

NOTE:

See the workstation Maintenance and Service Guide for installation details for the following

steps.

Prepare the workstation for component installation (see

installation on page

Remove the front bezel from the workstation.

Press gently on the edges of the optical drive bay filler panel, and remove it from the front bezel

as shown in the following figure.

Figure 3-4

Rotate the filler panel 90 degrees to a horizontal position.

Align the slots in the filler panel frame with the tabs in the front bezel. Press the optical drive filler

panel back into the front bezel until it snaps into place as shown in the following figure.

Figure 3-5

Chapter 3 Setting up the workstation

43).

Removing the ODD bay filler panel

Installing the ODD bay filler panel

Preparing the workstation for component

ENWW

Table of Contents