HP Z Workstation series User Manual page 72

Hide thumbs Also See for Z Workstation series:

Table of Contents

Connect the power and data cables to the optical disk drive as shown in the following figure. (An

HP Z600 Workstation is shown for example.)

Figure 10-5

Connect the optical disk drive data cable to the appropriate and available SATA port on the

system board as shown in the following figure (example shows HP Z600 Workstation).

NOTE:

SAS system board connectors. If there are not enough SATA connectors to accommodate all

drives, then connect all drives to the SAS system board connectors. Refer to the workstation

service label on the side access panel for SATA and SAS connector locations.

Figure 10-6

Replace all components that were removed in preparation for component installation.

Chapter 10 Installing optical disk drives

Connecting ODD power and data cables

All HP Z800 Workstation optical disk drives should be connected to either SATA or

Connecting the ODD data cable to the system board

ENWW

Table of Contents