HP Z Workstation series User Manual page 62

Hide thumbs Also See for Z Workstation series:

Table of Contents

To install a PCI or PCIe expansion card:

Follow the procedures described in

the workstation for component installation.

Align the card keyway with the slot key, and then firmly seat the card in the slot as shown in the

following illustration (1).

Figure 8-1

Close the retention clamp by rotating it downward (2) as shown in the illustration above.

NOTE:

retention clamp is secured by the PCI Card Support.

Connect all necessary power and interface cables to the card (follow instructions that came with

the expansion card).

Replace all components removed in preparation for component installation.

Chapter 8 Installing PCI/PCIe devices

Installing an expansion card

For the Z800, close the PCI retention clamp to make sure all cards are seated. The

Preparing for component installation on page 43

to prepare

ENWW

Table of Contents