HP Z Workstation series User Manual page 31

Hide thumbs Also See for Z Workstation series:

Table of Contents

On the back of the front bezel, squeeze the HP logo mounting tabs (1) and press the logo

outward (2) as shown in the following figure.

Figure 3-6

Rotate the HP logo 90 degrees counterclockwise, and then release the logo and press it back

into place in the front bezel.

Remove the EMI filler panels and remove the optical disk drive from the chassis.

Rotate the EMI filler panels and the optical drive 90 degrees as shown in the figure below, and

then reinstall them (see

Figure 3-7

Replace the front bezel and the side access panel when finished.

ENWW

Rotating the HP logo

Installing an optical drive (desktop configuration) on page

Reinstalling the optical drive

Converting to desktop configuration (Z400 only)

62.

Table of Contents