Converting To Desktop Configuration - HP Z600 - Workstation - 6 GB RAM User Manual

Converting to desktop configuration

This workstation can be operated in the mini-tower or the desktop configuration. Follow these steps to
convert to desktop configuration operation:
NOTE: See the workstation Maintenance and Service Guide for installation details for the following
steps.
1. Prepare the workstation for component installation (see
installation on page
2. Remove the front bezel from the workstation.
3. Press gently on the edges of the optical drive bay filler panel, and remove it from the front bezel
as shown in the following figure.
Figure 3-4
4. Rotate the filler panel 90 degrees to a horizontal position.
5. Align the slots in the filler panel frame with the tabs in the front bezel. Press the optical drive filler
panel back into the front bezel until it snaps into place as shown in the following figure.
Figure 3-5
22 Chapter 3 Setting up the workstation
40).
Removing the ODD bay filler panel
Installing the ODD bay filler panel
Preparing the workstation for component
ENWW