HP Z Workstation series User Manual page 53

Press the airflow guide release
latches as shown in the following
figure, and guide the airflow guide out
of the chassis.
6. Raise the expansion card retention clamp and remove the expansion card slot cover as shown
in the following illustrations, if applicable.
Open the card retention clamp at the
green touch points (1), and then lift
the slot cover from the chassis (2).
ENWW
Z400 (optional)
Z400
Z600
Disconnect the fan cable from the
system board (1), press the release
tab at the green touch point (2), and
then rotate the rear system fan
assembly from the chassis (3).
Press the release tab at the green
touch point (1), and then lift the
memory fan assembly from the
chassis (2).
Z600
Open the card retention clamp (1),
and then lift the slot cover from the
chassis (2).
Preparing the workstation for component installation
Z800
Remove the Z800 air flow guide as
shown in the following illustration, if
applicable.
Press the release tabs at the green
touch points (1), and then lift the
memory fan assembly from the
chassis (2).
Z800
Open the card retention clamp (1),
and then lift the slot cover from the
chassis (2).
45