Installing An Expansion Board - HP ProLiant DL585 User Manual

Slot
1
2
3
4
5
6
7
8
9

Installing an expansion board

CAUTION:
and remove all AC power cords before removing or installing the expansion boards.
CAUTION:
unless all expansion slots have either an expansion slot cover or an expansion board
installed.
Power down the server (on page 27).
1.
Extend the server from the rack ("Extending the server from the rack" on page 27).
2.
Remove the access panel ("Removing the access panel" on page 28).
3.
Open the latch, and remove the expansion slot cover.
4.
To replace the component, reverse the removal procedure.
Unlock the retaining clip (for full-length expansion boards).
5.
Description
PCI-X non-hot-plug expansion slot, 64-bit/100-MHz
(half-length)
PCI-X non-hot-plug expansion slot, 64-bit/100-MHz (full-
length)
PCI Express x4 non-hot-plug expansion slot (full-length)
PCI Express x4 non-hot-plug expansion slot (full-length)
PCI Express x8 non-hot-plug expansion slot (full-length)
PCI Express x4 non-hot-plug expansion slot (full-length)
PCI Express x8 non-hot-plug expansion slot (full-length)
PCI Express x8 non-hot-plug expansion slot (full-length)
PCI Express x4 non-hot-plug expansion slot (half-length)
To prevent damage to the server or expansion boards, power down the server
To prevent improper cooling and thermal damage, do not operate the server
Hardware options installation 47