Hardware Options Installation; Introduction; Processor Options; Removing The Processor Memory Module - HP ProLiant DL585 User Manual

Hardware options installation

Introduction

If more than one option is being installed, read the installation instructions for all the hardware options
and identify similar steps to streamline the installation process.
WARNING:
internal system components to cool before touching them.
CAUTION:
beginning any installation procedure. Improper grounding can cause electrostatic discharge.
Review "Electrostatic Discharge (on page 88)" before installing hardware options into the server.

Processor options

The server supports operation in a two- or four-processor configuration. The server supports boot functions
through the processor installed in processor socket 2.
Server PPMs provide the proper power to each processor. Each PPM must be installed in the slot adjacent
to its processor.

Removing the processor memory module

The processors and memory are stored in a module at the front of the server. Access to the processor
memory module is provided through the front panel, eliminating the need to extend the server from the
rack to install new or replace existing processors or upgrade the memory.
To remove the processor memory module:
Power down the server (on page 27).
1.
Release the latches on the lever.
2.
To reduce the risk of personal injury from hot surfaces, allow the drives and the
To prevent damage to electrical components, properly ground the server before
Hardware options installation 32