Install the hard drive.
3.
IMPORTANT:
drive is seated properly and receiving power.
Determine the status of the hard drive from the SAS and SATA hard drive LED combinations (on
4.
page 9).
Installing an expansion board
Power down the server (on page 26).
1.
Remove the access panel
2.
Remove the upper tray
3.
Remove the PCI riser board assembly
4.
Install the expansion board.
5.
When the drive is inserted, the drive LEDs flash for 2 seconds to indicate that the
("Removing and replacing the access
("Removing the upper
("Removing the PCI riser board
panel" on page 26).
tray" on page 27).
assembly" on page 28).
Hardware options installation 34