HP ProLiant DL585 User Manual page 41

To add memory to the server, observe the following DIMM installation guidelines:
•
DIMMs must be installed in pairs.
•
DIMM installed on the same memory bank must have the same part number.
•
DIMMs installed in different banks can be of different sizes.
•
DIMMs must be installed in decreasing capacity with the largest DIMMs installed in the banks
furthest from each processor.
NOTE: If all four banks on a memory node ("DIMM slot identification" on page 9) are
populated, the maximum memory clock speed is 533 MHz. If two or fewer banks on a
memory node are populated, the maximum memory clock speed is 667 MHz.
To install a DIMM:
Power down the server (on page 27).
1.
Remove the processor memory module, and open the cover ("Removing the processor memory
2.
module" on page 32).
Open the DIMM slot latches.
3.
Install the DIMM.
4.
Hardware options installation 41