Installation and Setup
Mounting the Camera
Preparing the Mounting Surface
20
1.
Affix the mounting template (see
Figure
2-1.
2.
Pre-drill three holes as indicated on the template, using the recommended hole size
for the screws being used.
3.
Drill out conduit hole, if required (see
Figure 2-1
Mounting Template Guide
Note
Alternate fasteners (preferably stainless steel) can be used, provided they are
not larger than the screw holes on the mounting template.
Appendix
A) to the mounting surface as shown in
Installing the Conduit
Plug, page 22).