Interfacing With The Equip Device Via A Network Video Recorder - Honeywell HD4DIP Reference Manual

Installing the Honeywell IP Utility and Web-Client Software

Interfacing with the EQUIP Device Via a Network Video Recorder

40
Updating IP Network Settings Manually
Caution When manually updating the network settings, it is important to enter
the correct IP network settings before applying them. Incorrect values
may cause a failure when connecting to the device. See
definitions of each setting.
1. In the Discovery pane, select the device and click Connect
2. To assign a static IP address to the device, from the System tab click to clear the
Obtain an IP Address automatically check box.
3. Type in a Device Name, for example, FrontLobby01.
Note The MAC address is a factory assigned address that is unique for each
device.
4. Type in an IP Address of the device on the network.
Note The address must be in the same address range. For example, if the PC is
192.188.1.xx, then the device should be set to a similar address, for example
192.168.1.xy.
5. Type in the device Subnet Mask value. A value is required.
6. Type in a default Gateway Address that connects the device to the static network. A
value is required.
7. Click Apply.
The network settings are updated and a message displays in the status bar to confirm
the update.
Your recording vendor has the option of using either the connection methods supported by
EQUIP V1 firmware or EQUIP V2.1 firmware. If the NVR vendor has implemented EQUIP V1
connection methods, the HD4DIP camera will work on those NVRs. Similarly, if the NVR
vendor has implemented EQUIP V2.1 connection methods, the HD4DIP camera will work
on those NVRs. There is no user configuration necessary.
For further information, refer to the documentation supplied with your NVR or contact your
NVR network administrator.
Table 3-4 for
.