Bridge Mode; Bridge Mode - D-Link DAP-1360 User Manual

Section 3 - Configuration
Enable Wireless:
Select this to turn the Wi-Fi module on and off. Use the
drop-down box to select if you want to use a schedule.
Click Add New to add or change a schedule.
Wireless Mode: Select Bridge from the drop-down menu.
Wireless Network
The Wireless Network Name is a unique name that
Name: identifies a network. All devices on a network must share
the same wireless network name in order to communicate
on the network. If you decide to change the wireless
network name from the default setting, enter your new
wireless network name in this field.
802.11 Mode:
Select the appropriate 802.11 mode based on the wireless
clients in your network. The drop-down menu options
are 802.11g Only, Mixed 802.11b/g, 802.11b Only,
802.11n Only, or Mixed 802.11b/g/n.
Wireless Channel: All devices on the network must share the same channel.
Enable Auto
The Auto Channel Scan setting can be selected to allow
Channel Scan:
the DAP-1360 to choose the channel with the least
amount of interference.
Select the appropriate channel width between 20MHz
Channel Width:
or Auto 20/40MHz from the drop-down menu.
Select the transmission rate. It is strongly suggested to use the Auto setting for optimal performance.
Visibility Status:
Enter the MAC addresses of the APs in your network that will serve as bridges to wirelessly connect multiple networks.
Remote AP MAC:
Select None to disable encryption to across the network. Select WEP 64-bit or WEP 128-bit to limit communication to only those
Bridge Security:
devices that share the same WEP settings. Select WPA-PSK or WPA2-PSK to secure your network using a password and dynamic key
changes (No RADIUS server required).
Note: The Bridge mode is not completely specified in the Wi-Fi or IEEE standards. This mode can work with other DAP-1360 units. Communication with
other APs (even other D-Link APs) is not guaranteed.
D-Link DAP-1360 User Manual

Bridge Mode

39