Using the Configuration Menu (continued)
Advanced > Mode (continued)
Enter the
MAC address
to configure the
Wireless Client mode
When using the DWL-2000AP in Wireless
Client mode, you will enter the MAC ad-
dress of the Remote AP.
Find the MAC address of the DWL-2000AP that is acting as a Remote Access
Point or a Remote Bridge, by going to Status > Device Info in the configura-
tion utility of the remote DWL-2000AP. There you will find the MAC address as
shown above.
MAC Address - Media Access Control Address
A unique hardware address that identifies a device on a network. It is assigned at
the factory and cannot be changed. Usually you will find this address on a sticker
on the device or packaging.
Wireless Client
and the
Wireless Bridge
When using the DWL-2000AP in
Wireless Bridge mode, you will enter
the MAC address of the Remote Bridge.
modes
Wireless Bridge mode
18