Defining The Preset Setup String - Peavey PC1600X User Manual

------------------------------------------------------------------------------
When a preset is selected/recalled, each MIDI channel can send out an associated bank select message,
Program change message and volume message. The preset string can also be linked to a scene in addition to
an 80- byte programmable string.
BANK/PROGRAM/VOLUME
To program these options:
1. Press Edit, then select "Setup string". Next, press "Enter" to access one of the three set-up pages. The
bank select, program chance and volume for each channel are available on the first page:
2. Cursor right to the "Ch" field. Changing this field causes the bank, program and volume fields to display
the information for the selected channel.
3. Cursor right to the "Bank" field. This field displays the bank number to be sent for this channel.
Decrementing this field below zero (off) causes no bank message to be sent. When the Bank parameter is set
to 0-127, the full Bank Select message is transmitted with a zeroed MSB and the Bank number in the LSB.
Some products use the MSB directly to chance bands ignoring the LSB. Because of this the PC1600Xs Bank
parameter can be incremented further past 127. This new range is shown as 001m - 127m. When one of these
values is used the Bank will be sent as the MSB and the LSB won't be sent. For example, bank 002n on
Channel 1 would be transmitted as follows:
Hex
Description
NOTE:
There is no "000m" choice in the list.
To switch an "MSB" unit to bank #0, use the 000 (LSB) selection since that will send a zeroed MSB along
with the zeroed LSB.
More About Bank Select
MIDI specifies the Bank Select message as a full l4-bit controller message, (Two 7-bit controllers combined
into a 14-bit number). The MSB (Most Significant Byte) is controller #0, while the LSB (Least Significant
Byte) is controller #32 (#20h). The bank number is computed as (MSB * 128) + LSB, hence, to switch to
bank #2 on Channel 5, the MIDI message would look like this:
Hex B4
Description Status
4. Cursor right to the "Prog" field. This field displays the program number to be sent for this channel.
Decrementing this field below zero (off) causes no program message to be sent.
5. Cursor right to the "Vol" field. This field displays the volume to be sent for this channel. Decrementing
this field below zero(0) causes no volume message to be sent.
Defining The Preset Set-Up String
Setup; Bank
Ch01 Off
B0
Status
00
CC#0
Peavey PC1600X User Manual (rev-h)
Prog Vol
Off Off
00
CC#
00 20
MSB CC#32
43
02
MSB
02
LSB