Program Change Enable And Current Map Status; Dumping Internal Data - Peavey PC1600X User Manual

should not be confused with the current MIDI map described below.
4. Cursor right again to the third field which displays a preset or scene number, this is the preset number
recalled or scene sent when the program change value in the second field is received. If a preset is selected,
the bottom line will display the preset name. When a scene is selected, the associated preset number will be
displayed.
Note:
Program Change Map1 and Map2 default to recall presets 0-49 with received Program changes 0-49.
Program Change Map3 defaults to send Scenes 0-99 with received Program changes 0-99.

PROGRAM CHANGE ENABLE AND CURRENT MAP STATUS

The current MIDI MAP parameter selects which map incoming program chances will use. Incoming
program chances can be ignored completely by setting the current map number to "Off".
To set the current map number:
1. Press the Utility button.
2. Use the no/down buttons or data wheel to access the following Dace:
3. Cursor right once to activate the field and use the Up/Down direction buttons or data wheel to edit the
marl number.
4. To ignore all incoming program changes, decrease the current map number until "off" is displayed.

DUMPING INTERNAL DATA

ALL internal data can be transmitted over MIDI to be saved on an external device. The MIDI Dump page
allows the following data to be transmitted:
ALL presets
All scenes
All global variables
The current preset
Everything
To transmit this information:
1. Press the Utility button.
2. Use the Up/Down buttons or data wheel to access the following page:
3. Cursor right once to activate the field and use the Up/Down direction buttons or data wheel to edit the type
of data to be transmitted.
4. Press the "Enter" button to transmit the data.
Note:
Data dumps can also be requested remotely using the appropriate SysEx message (see Appendix A)
MAP1: Curr MIDI map
Off
UTIL: dump [Enter]
Everything
20
Peavey PC1600X User Manual (rev-h)