Table of Contents
Advertisement
SEND FADER
This feature allows you to send single messages (as opposed to "sweeps" of messages) from the faders. This
is desirable in many cases like when sending very precise control chances into a sequencer.
When a fader's button is programmed as "Send Fader" moving the fader will not cause a MIDI transmission.
You will however see the data value on the top preset screen as you would normally except that there will be
an "M" in the lower right corner of the LCD telling you that the fader is temporarily muted. After you move
the fader to the desired position press the button to send the message (you will see the "M" disappear
signaling that the message was sent).
You can also use the Data Wheel to change the value before it is actually sent, if I is linked to the fader
(either directly or with "Last Fader"). Pressing a "Send Fader" button will switch to the "Last Fader Moved"
(even if the fader itself was not moved).
You can also set a normal "Sweep" from the fader by holding the button while moving the fader (or data
wheel). In this case the "M" will not be on the LCD signaling that the message is being transmitted.
NOTE:
When using faders to send continuous controller messages the replace and update modes will be
unaffected by fader movements when the button is not pressed, In other words the incoming controller won't
get filtered until the local controller is REALLY transmitted.
SEND SCENE
You can send any scene from one of the 16 buttons. This is useful when you know that you're
going to transmit particular scenes from a preset. It saves you from having to go to the
SCENE page, choose the scene and then send it with the "ENTER" button.
Choose "Send Scene" as the button function and the next screen will allow you to nick the
desired scene.
SAVING YOUR EDITS
Use the following steps to save your edits:
1. Press the Edit button.
2. Use the data wheel, Up/Down buttons or press button 16 to scroll to the last option: Name/save preset.
3. Press "Enter".
4. To re-name use the left/right buttons to select character positions and the Up/Down buttons to edit the
character. Note: Faders also can be used to select character positions.
5. Press "Enter".
6. Choose the destination preset (will be overwritten).
BTN01:
Function
Send Fader
BTN01:
Function
Send Scene
BTN01:
Scene
[p:32]
02
40
Peavey PC1600X User Manual (rev-h)
Hide quick links:
Advertisement
Table of Contents
