Program Change - Peavey PC1600X User Manual

MUTE/SOLO FADER
A button can be assigned to mute the associated fader. Pressing the button will mute the fader by sending the
minimum value for the fader, and then disable the fader. When muted, moving the fader will have no effect.
When the button is pressed again, the current fader message is sent, and the fader is enabled. To program a
button to mute the associated fader, simple select "Mute fader" for the button function.
A button can be programmed to Solo the associated fader my simply selecting "Solo Fader" function for the
button. With this function, pressing the button will send the minimum value for each fader except the
button's associated fader. To restore any fader, simply move the desired fader. To cancel the Solo entirely,
simply press ""Enter"' button with the "main" page displayed.

PROGRAM CHANGE

A button can be assigned to send a program chance message each time it is pressed. The MIDI channel can
be set to any MIDI channel, or to the main transmit channel set in the Utility section. The program number
can be any value from 000 to 127.
To set these two parameters:
1. From the button function page, select "Program Chng". Next, deselect then press the up direction button.
The following page will be displayed:
2. Cursor over to the "Chin" field and set the MIDI channel for the program change message. Incrementing
the channel number above 16 will display "ChOut." When "ChOut" is selected, the program change message
will be transmitted on the Global MIDI channel set in the Utility menu.
3. Cursor over to the "Program" field to set the program number.
NOTE ON/OFF
A button can be assigned to send a note-on message when the button is pressed, and a note-off message
when the button is released. The MIDI channel can be set to any specific channel, or to the main transmit
channel set in the Utility section. The note number can be set to any note from C-1 to G9. The velocity can
be set to any specific value (1-127), determined by the current fader position fair), or determined by
incoming MIDI velocity (Rem) when button remote is used.
To set the parameters:
1. From the button function page, select "Note-on/off." Next, deselect then press the up direction button. The
following page will be displaced:
2. Cursor over to the "ChIn" field and set the MIDI channel. Incrementing the channel number above 16 will
display "ChOut", which references the global MIDI channel.
3. Cursor over to the "Note" field to set the note number.
4. Cursor over to the "Vel" field to set the velocity value. Incrementing the velocity value above 127 will
BTN16: Chn1 Program
01 000
BTN16: Chn1 Note Vel
01 C4
35
Peavey PC1600X User Manual (rev-h)
127