Peavey PC1600X User Manual page 42

------------------------------------------------------------------------------
EDITING CV 1 & CV 2
The CV 1 and CV 2 inputs will accept a Control Voltage foot pedal. Press EDIT. then select CV 1 or CV 2.
Press "ENTER" to move to the function edits page:
Control voltage inputs are programmed like the faders. Refer to the "Editing the Faders" chapter describing
how to define a fader.
Note:
The dual footswitch parameters must be disabled (turned off) for CV 2 to work correctly.
WHAT TYPE OF CONTROL VOLTAGE PEDAL IS REQUIRED
Any 0-10 volt control voltage pedal or 1OK potentiometer pedal (unpowered) should work. As of this
writing, both Roland (EV-5, EV-1O) and Ensoniq (CVPI) offer control voltage pedals that will work with
the PC1600x.
DUAL FOOTSWITCH EDITING
The dual footswitch is set up globally in the Utilities menu, each pedal can be programmed to control:
Up/Down
"Enter"
Button functions
EDITING THE DATA WHEEL
The data wheel is programmed by linking it to a fader or CV input. When the data wheel is linked to a Fader,
CV input, it will adjust that parameter using the current Fader, CV position as a starting point. The data
wheel can also be set to link to the last Fader/CV moved instead of a specific fader.
1. Press EDIT, then select "Data Wheel, Press "Enter" to move to the following page:
2. Use the Up/Down buttons or the data wheel to select a fader or CV input. Also, moving a fader or CV
input will cause them to be selected.
3. Increment until "Last moved is displayed to make the data wheel always edit the last fader or CV input
that was moved.
CV Pedals, Footswitch & Data Wheel
CV 1: function
No Message
Wheel; Link
None
42
Peavey PC1600X User Manual (rev-h)