Static Addressing Pre-Installation Checklist; Static Addressing Installation 3 - Avaya INDEX 4602 Installation Manual

Index 4602 ip telephone
Hide thumbs Also See for INDEX 4602:
Table of Contents

Advertisement

Page 8 - IPNC Setup

Static Addressing Pre-Installation Checklist

Before performing static addressing on the 4602 IP Telephone, verify that have
the values for the following parameters. Failure to do so may cause errors
during data entry, which will prevent the telephone from working and may have
a negative impact on your network. Consult your network administrator and print
copies of this checklist for each subnet.
1. The IP Address of the call server/gatekeeper.
2. The IP Address to be allocated to the 4602 IP Telephone.
3. The transport layer port number of the Address of the Management
4. The IP Address of the gateway/router
5. The IP netmask
6. The IP address of the TFTP server.
Static Addressing Installation
The usual way to assign IP addresses to IP Telephones is the automatic
method described in Dynamic Address Process on page 6. There may be times,
however, when manual assignment of IP addresses is desired.
The display on the 4602 IP Telephones accommodates up to 24 characters per
line.
Use the following procedure to invoke manual address information
programming.
1. Start manual address programming by performing one of the following
or
2. Enter the IP address for the telephone followed by the # button.
Page 8 - IPNC Setup
Installation Procedure
Complex (call server/gatekeeper). Although this may be a value between 0
and 65535, the default value is 1719 and should not be changed unless this
conflicts with an existing port assignment.
steps:
a. During normal DHCP processing, press the * key before the DHCP
process completes.
b. While the phone is on-hook and idle, press the following sequence of
keys on thefaceplate of the telephone:
Mute 2 3 3 7 # (Mute A D D R #)
Press the Mute button momentarily. Do not press this button while
pressing other keys/ buttons.
The following message is displayed:
Phone=nnn.nnn.nnn.nnn
New=_
where "nnn.nnn.nnn.nnn" is the value of the telephone.
The following message is displayed:
CallsSv=nnn.nnn.nnn.nnn
New=_
where "nnn.nnn.nnn.nnn" is the value of the call server/gatekeeper IP
address.
INDeX 4602 IP Telephone Installation Manual
38DHB0002UKCQ – Issue 2 (11/06/2003)
Installation Procedure

Advertisement

Table of Contents
loading

Table of Contents