Noise Reduction; Color Space - Christie DS+6K User Manual

Section 3: Operation
3-26
setting. In high ambient light conditions, lower gamma may produce better results
than higher gamma. Gamma of 2.2 (default) indicates the gamma table has not been
adjusted. For more information, refer to Advanced Image Settings submenu, Gamma
Table. Again, good gamma improves contrast while maintaining good details for
blacks.
Filter
The proper filter setting is automatically set for virtually all
signals, and rarely needs to be changed. It applies a low pass
filter for noise reduction in the incoming input signal,
particularly for HDTV or SDTV. Applied in the analog domain
before sampling, this filtering removes high frequencies and thus reduces pixel phase
noise (note this also reduces signal bandwidth). Override only if standard pixel
tracking and phase adjustments do not adequately clear up a "noisy" video signal, or if
a graphics signal appears overly "soft". Both instances indicate that "Filter" may be
set to the wrong option.
Detail
"Detail" adjusts the sharpness of a video image so that edges remain clearly defined. It
can be particularly useful if a significant "Noise Reduction" adjustment has caused the
image to appear too soft. Adjust until the display is as sharp as desired, keeping in
mind that because "Detail" adds some high frequencies back into the image, it can
also re-introduce a certain degree of noise.

Noise Reduction

"Noise Reduction" is similar to the "Filter" control, but operates in the post-sampling
digital domain with a more subtle effect. Higher settings are most useful for clearing
up noisy RGB images such as those from a PC. Adjust as desired, keeping in mind
that reducing noise (which reduces high frequencies) may also soften the image.

Color Space

"Color Space" determines how the color components of an
analog input signal are decoded for accurate color in the display.
Selecting a color space option is useful only for analog signals
and certain digital sources connected to
or Although color space for these analog signals is
5 INPUT 6.
automatically determined by the projector, in some circumstances you may wish to
override this and manually set a specific color space.
NOTE: For many digital signals or for signals connected to
color space function is entirely automatic and the pull-down list disabled.
The current color space appears in the Image Settings menu. Press
different option:
•
Select unless you are using component video at
RGB
•
Select
YPbPr (Video)
•
Select
YPbPr (HDTV)
INPUT 1, INPUT 2, INPUT
with a standard definition televised signal (SDTV).
with a high definition televised signal (HDTV).
INPUT 3 INPUT 4
or , the
to select a
or
INPUT 1, 2, 5 6.
020-100001-01 Rev. 01 (04/07)