Christie DS+6K User Manual page 53

Section 3: Operation
3-24
BLANKING (TOP, BOTTOM, LEFT, and
Crop the image as desired so
RIGHT):
that unwanted edges are removed from
the display (changed to black—see
right). Blanking defines the size of the
Active Input Window, or area of
interest. Range of adjustment depends
on the source resolution and other
factors. After adjustment of blanking it
may be necessary to perform a source
switch.
NOTE: Blanking a PIP image
resembles zoom (see Figure 3.6). For
example, left Blanking zooms the right
side of the PIP image; Right Blanking
zooms the left side. There are no black
bars.
PLUG & DISPLAY (EDID):
(EDID) source outputs a signal according to the
EDID information provided by the projector. To
override this information and display in a different
format (for example, if your Plug & Play [EDID]
device does not support the projector's resolution
and/or frequency), select the desired Plug & Play
(EDID) resolution from the list.
Any daisy-chained projectors will also display
according to the chosen Plug & Play (EDID) format.
EDID = Extended Display Identification Data standard.
Blanking of a Primary Image
Figure 3.6. Blanking of a PIP Image
By default, a Plug & Play
020-100001-01 Rev. 01 (04/07)