Restoring All Keymoved Keys In A Single Mode; Programming Favorite Channel Scan - Radio Shack 8-in-One Remote User Manual

8-
USING KEYMOVER (continued)
R A K
ESTORING LL EYMOVED
1. Perform steps 1 through 4 of the earlier section, Programming Keymover,
on page 26. However, this time in steps 3 and 4, make the source mode and
source key the same mode (e.g., TV). [CLR KMVR] appears.
2. Press SELECT once to clear all keymoved keys from this mode. [DELETED]
appears, followed by [EXIT SETUP]. The remote will automatically exit the
programming mode and return to normal operation.

PROGRAMMING FAVORITE CHANNEL SCAN

In the TV, VCR, DVD, SAT, or CBL mode, the remote can store a list of up to 10 favorite
channels, in any order, that will be immediately scanned when you press SCAN (FAV) once
(see Using Channel Scan on the next page).
NOTE: Only channels of one mode can be stored and any previously-stored channels will be cleared.
On the remote, press and hold P until the display changes from the default
1.
device and time to [CODE SET].
NOTE: Default values for device, its code, and time are shown above.Your remote control
settings may be different.
NOTE: If you wish to exit the programming mode at any time, press EXIT once. An
[EXIT] message appears as the remote control returns to normal operation.
NOTE: If an [INVALID] message appears, you have inadvertently pressed an incorrect
key. Simply note your error and continue programming.
▲
2. Press three times until [FAV CHAN] appears.
(x 3)
NOTE: If you go past [FAV CHAN], press
3. Press SELECT once to begin programming. The last-selected device (e.g.,
[VCR]) appears.
4. Select a mode (e.g., TV) for favorite channel scanning and press it once. Then
press SELECT once. [FAV] appears.
28 Using Keymover/Programming Favorite Channel Scan
-O R
IN NE EMOTE
K I A S M
EYS N INGLE ODE
▼
one or more times to return to it.