Programminga Master Power Key With Instant Channel Selection - Radio Shack 8-in-One Remote User Manual

▼
2. Press six times until [KEY MACRO] appears.
(x 6)
NOTE: If you go past [KEY MACRO], press
Press SELECT once to begin programming. [SEL MACKEY] appears.
3.
4. Select a key you want to use as a macro and press it once. [ENTER SEQ] appears.
5. Enter a macro sequence of up to 15 keys. For our example, press the following
keys once in this order: TV - 7 - 1.
NOTE: If you have access to over 100 channels, add a 0 before the channel numbers (e.g.,
0 -7 - 1). If the original remote control required pressing an Enter key to change the
channel, also press ENTER after the channel number (e.g., 0 - 7 - 1 - ENTER).
NOTE: An [ERROR] message, followed by [MAX = 15] alerts you that the macro
sequence must be 15 keys or less.
After pressing the first key (in the macro sequence), [SEL TO END] appears as a
reminder to use SELECT to end the sequence (see next step).
To end the macro sequence, press and hold SELECT until [SUCCESS] appears,
6.
followed by [EXIT SETUP]. The remote will automatically exit the programming
mode and return to normal operation.
Now when you press the key with this assigned macro, you will instantly see cable channel 71
on your TV set.
P A M
ROGRAMMING ASTER
A macro key can be programmed to turn on and off your devices as well. For example, let's
set up a sequence that will turn on the TV and tune it to channel 3, and then turn on the
cable converter and tune it to a premium channel (e.g., 11).
NOTE: This example assumes all equipment is turned off and that the TV is connected through the
cable converter with TV tuning set to channel 3.
1. Perform steps 1 through 4 of the previous section, Programming A Favorite
Channel on the previous page. However, this time in step 4, substitute another
key for use as a macro key.
2. Enter a macro sequence of up to 15 keys. For our example, press the following
keys once in this order: CBL - POWER - TV - POWER - 0 - 3 - CBL- 1 - 1
NOTE: If you have access to over 100 channels, add an
numbers (e.g., 0 - 0 - 3 and 0 - 1 - 1). If the original remote control required pressing
an Enter key to change the channel, also press ENTER after each channel number
(e.g., 0 - 0 - 3 - ENTER and 0 - 1 - 1 - ENTER).
NOTE: An [ERROR] message, followed by [MAX = 15] alerts you that the macro
sequence must be 15 keys or less.
▲
one or more times to return to it.
P K W I
OWER EY ITH NSTANT
U '
SER S
C S
HANNEL ELECTION
0
before each set of channel
continued on next page...
Using Macros 25
G
UIDE