Programming Volume Unlock - Radio Shack 8-in-One Remote User Manual

NOTE: Default values for device, its code, and time are shown above.Your remote control
settings may be different.
NOTE: If you wish to exit the programming mode at any time, press EXIT once. An
[EXIT] message appears as the remote control returns to normal operation.
NOTE: If an [INVALID] message appears, you have inadvertently pressed an incorrect
key. Simply note your error and continue programming.
▼
2. Press four times until [VOL LOCK] appears.
(x 4)
NOTE: If you go past [VOL LOCK], press
3. Press SELECT once to begin programming. [TO MODE] appears.
4. Press a mode key (e.g., AUDIO) to lock a device's volume controls to all modes.
[SUCCESS] and then [EXIT SETUP] appear as the remote control automatically
exits the programming mode and returns to normal operation.
5. If desired, repeat steps 1 through 4 as needed to lock volume controls for other
devices to all modes.
P V U
ROGRAMMING OLUME
On the remote, press and hold P until the display changes from the default
1.
device and time to [CODE SET].
▼
five times until [VOL UNLOCK] appears.
2. Press
(x 5)
NOTE: If you go past [VOL UNLOCK], press
3. Press SELECT once to begin programming. [ALL MODE] appears.
To unlock one mode, skip to step 4. Otherwise press SELECT once to unlock
all modes. [UNLOCKED] and then [EXIT SETUP] appear as the remote
automatically exits the programming mode and returns to normal operation.
▲
one or more times to return to it.
NLOCK
▲
U '
SER
one or more times to return to it.
continued on next page...
Changing Volume Lock 23
G
S UIDE