Assembly - Horizon Fitness T901 User Manual

ASSE M B LY
IMPORTANT: READ THESE SAFETY INSTRUCTIONS BEFORE USE!
WARNING
During the assembly process of the treadmill there are several areas that special attention must be
paid. It is very important to follow the assembly instructions correctly and to make sure all parts are
firmly tightened. If the assembly instructions are not followed correctly, the treadmill could have
frame parts that are not tightened and will seem loose and may cause irritating noises. There should
be no side-to-side play in the console masts or any forward and back play in the console assembly
or handlebars. If there is any play in these areas, the treadmill has not been properly assembled. To
prevent damage to the treadmill, the assembly instructions must be reviewed and corrective actions
should be taken.
UNPACKING
Place the treadmill carton on a level flat surface. It is recommended that you place a protective
covering on your floor. Take CAUTION when handling and transporting this unit. Never open box when
it is on its side. Once the banding straps have been removed, do not lift or transport this unit unless
it is fully assembled and in the upright folded position or until specified in the assembly instructions.
Unpack the unit where it will be used. The enclosed treadmill is equipped with high-pressure shocks
and may spring open if mishandled. Never grab hold of any portion of the incline frame and attempt to
lift or move the treadmill. FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN INJURY!
Before proceeding, find your treadmill's serial number
and model name located to the left of the on/off
power switch and power cord and enter it in the space
provided below.
ENTER YOUR SERIAL NUMBER AND
MODEL NAME IN THE BOxES BELOW:
SERIAL NUMBER:
MODEL NAME:
* Refer to the SERIAL NUMBER and MODEL NAME when calling for service.
* Also enter this serial number on your Warranty Card.

T901_Rev.2.0.indd 6-7
LED DISPLAY WINDOWS
IPOD DOCKING STATION
AUDIO-IN JACK
PULSE GRIPS
HEADPHONE JACK
ON/OFF SWITCH
CIRCUIT BREAKER
POWER CORD
TRANSPORT WHEEL
RUNNING BELT / RUNNING DECK
TOOLS INCLUDED
Screwdriver 10 mm L-wrench
c c
5 mm T-wrench 6 mm T-wrench
c c
PARTS INCLUDED
1 Console Assembly 1 Safety Key
c c
(located under treadmill deck)
1 Bottle of Silicone Lubricant
c
2 Console Masts
c
3 iPod
c
2 Handlebars
c
1 Universal MP3 Player Dock Insert
c
2 Support Bars
c
1 iPod
®
c
2 Water Bottle Pockets
c
1 Audio Adaptor Cable
c
6 Hardware Bags
c 1 Power Cord
c
1 Right Linkage Arm
c
If you have questions or if there are any missing parts, contact Customer Tech Support.
Contact information is located on the back panel of this manual.
For a complete exploded diagram, visit us at www.horizonfitness.com
WATER BOTTLE POCKET
CONSOLE
HANDLEBAR
SUPPORT BAR
SAFETY KEY PLACEMENT
CONSOLE MAST
MOTOR COVER
FOOT LOCK LATCH (UNDER DECK)
SIDE RAIL
ROLLER END CAP
REAR ROLLER
ADJUSTMENT BOLTS
10 mm/13 mm Flat Wrench
c
Dock Inserts
®
Docking Station Rubber Plug

9/10/08 11:15:18 AM