Horizon Fitness T901 User Manual page 5

P R E-ASS E MB LY
DO NOT ATTEMPT TO LIFT THE TREADMILL!*
WARNING
treadmill from packaging until specified to do so in the assembly instructions.
Failure to do so may result in injury! Remove plastic wrap from console masts.
NOTE: During each assembly step, ensure that ALL nuts and bolts are in place and partially threaded in
before completely tightening any ONE bolt. NOTE: A light application of grease may aid in the installation
of hardware. Any grease, such as lithium bike grease is recommended.
DO NOT
EXCEED
45
DEGREES!
* NOTE: If you have lifted the treadmill deck too far or attempted to move the machine and it has
sprung open and cannot be assembled, refer to the troubleshooting section in order to restore the
treadmill to its proper position.

T901_Rev.2.0.indd 8-9
ASSEMBLY STEP 1
HARDWARE BAG 1 CONTENTS :
Do not move or lift
A Cut the yellow banding
straps.
B Raise the deck slightly
– NO MORE THAN 
DEGREES – to remove
all contents from
underneath the deck.
A Open HARDWARE BAG 1.
B Move LEFT LINKAGE ARM into position. Insert 1 BOLT (A) and 1 FLAT WASHER (B) into LEFT LINKAGE
ARM followed by 1 TEFLON WASHER (C) and attach to ELEVATION FRAME.
C Lift LEFT CONSOLE MAST into upright position. Be sure to hold the
console mast firmly, as it will not stay in the upright position on its own.
D Insert 1 BOLT (D) and 1 FLAT WASHER (E) through LEFT CONSOLE
MAST followed by 1 WAVY WASHER (F) and attach to MAIN FRAME.
NOTE: Do not completely tighten any screws or bolts until step 6 is complete!
BOLT (A) FLAT WASHER (B)
15 mm 20 mm
Qty: 1 Qty: 1
BOLT (D) FLAT WASHER (E)
Qty: 1 27 mm
Qty: 1
LEFT CONSOLE MAST
WAVY WASHER (F)
FLAT WASHER (E)
BOLT (D)
LEFT LINKAGE ARM
BOLT (A)
FLAT WASHER (B)
TEFLON WASHER (C)
TEFLON WASHER (C)
18 mm
Qty: 1
WAVY WASHER (F)
29 mm
Qty: 1
MAIN FRAME
ELEVATION FRAME
9
9/10/08 11:15:21 AM