Pre-Assembly; Assembly Steps; Hardware Bag Contents - Horizon Fitness T82 User Manual

PR E- AS S EM BLY
WARNING
NOTE:
During each assembly step, ensure that ALL nuts and bolts are in place and partially threaded in before
completely tightening any ONE bolt. NOTE: A light application of grease may aid in the installation of hardware.
Any grease, such as lithium bike grease is recommended.
A S SE MB LY S T E P 1
HARDWARE BAG 1 CONTENTS :
LEFT CONSOLE MAST
WAVY WASHER (F)
FLAT WASHER (E)
BOLT (D)
LEFT LINKAGE ARM
A Open HARDWARE BAG 1.
B Cut banding straps. Do not move or lift treadmill from packaging.
C Move LEFT LINKAGE ARM into position. Insert BOLT (A) and FLAT WASHER (B) into LEFT
LINKAGE ARM followed by a TEFLON WASHER (C) and attach to ELEVATION FRAME.
D Lift LEFT CONSOLE MAST into upright position. Be sure to hold the console mast firmly, as
it will not stay in the upright position on its own.
E Insert BOLT (D) and 1 FLAT WASHER (E) through LEFT CONSOLE MAST followed by a
WAVY WASHER (F) and attach to MAIN FRAME.
8
DO NOT ATTEMPT TO LIFT THE TREADMILL!*
from packaging until specified to do so in the assembly instructions. Failure to do
so may result in injury! Remove plastic wrap from console masts.
BOLT (A)
15 mm
Qty: 1
BOLT (D)
Qty: 1
BOLT (A)
FLAT WASHER (B)
TEFLON WASHER (C)
Do not move or lift treadmill
FLAT WASHER (B) TEFLON WASHER (C)
20 mm 18 mm
Qty: 1 Qty: 1
FLAT WASHER (E) WAVY WASHER (F)
27 mm 29 mm
Qty: 1 Qty: 1
MAIN FRAME
ELEVATION FRAME