Table of Contents
Advertisement
Chapter 3
Maintaining the Server
Figure 3-7
2
1
1
3
Replacing an Internal Flash eUSB Drive
The eUSB drive is a small solid-state flash drive card that connects to the motherboard in either of two
eUSB drive connectors.
The qualified and supported part numbers for this component are subject to change over time. For the most
up-to-date list of replaceable components, see the following URL and then scroll to Technical Specifications:
http://www.cisco.com/en/US/products/ps10493/products_data_sheets_list.html
This section contains the following topics:
•
•
Replacement Procedure
To install or replace the eUSB drive, follow these steps:
Step 1
Remove the eUSB drive you are replacing. See
a.
b.
Note
You might have to detach cables from the rear panel to provide clearance.
OL-22326-01z
Removing and Replacing the I/O Riser
3
Retaining clip
I/O riser
Replacement Procedure, page 3-13
Enabling or Disabling the Internal USB Port, page 3-15
Power off the server as described in the
page
3-6.
Slide the server out the front of the rack far enough so that you can remove the top cover.
Installing or Replacing Server Components
2
I/O riser back panel
Figure
3-8:
"Shutting Down and Powering Off the Server" section on
Cisco UCS C460 Server Installation and Service Guide
3-13
Advertisement
Table of Contents
