Table of Contents
Advertisement
Installing or Replacing Server Components
Installing or Replacing Server Components
Blank faceplates and cover panels serve three important functions: they prevent exposure to
Warning
hazardous voltages and currents inside the chassis; they contain electromagnetic interference (EMI)
that might disrupt other equipment; and they direct the flow of cooling air through the chassis. Do not
operate the system unless all cards, faceplates, front covers, and rear covers are in place.
Statement 1029
Class 1 laser product.
Warning
Statement 1008
Caution
When handling server components, wear an ESD strap to avoid damage.
Tip
You can press the Identification button on the front panel or rear panel to turn on a flashing Identification
LED on the front and rear panels of the server. This allows you to locate the specific server that you are
servicing when you go to the opposite side of the rack. You can also activate these LEDs remotely by
using the CIMC interface. See the
LEDs.
This section describes how to install and replace server components, and it includes the following topics:
•
•
•
•
•
•
•
•
•
•
•
•
•
Cisco UCS C22 Server Installation and Service Guide
3-10
Replacing Hard Drives or Solid State Drives, page 3-11
Replacing a Front Operations Panel Board, page 3-12
Replacing a Drive Backplane, page 3-14
Replacing Fan Modules, page 3-16
Replacing DIMMs, page 3-17
Replacing CPUs and Heatsinks, page 3-22
Replacing the Motherboard RTC Battery, page 3-27
Replacing a PCIe Riser, page 3-28
Replacing a PCIe Card, page 3-30
Replacing a Cisco USB Flash Drive, page 3-33
Replacing the SuperCap Power Module (RAID Backup Unit), page 3-37
Installing a Trusted Platform Module, page 3-39
Replacing Power Supplies, page 3-42
"Status LEDs and Buttons" section on page 3-2
Chapter 3
Maintaining the Server
for locations of these
OL-26646-01
Advertisement
Table of Contents
