Table of Contents
Advertisement
Chapter 3
Maintaining the Server
Removing and Replacing the Server Top Cover
To remove or replace the top cover of the server, follow these steps:
Tip
You do not have to remove the cover to replace hard drives or the power supply.
Step 1
Remove the top cover (see
a.
b.
c.
Replace the top cover:
Step 2
a.
Note
b.
c.
Figure 3-3
1
1
2
3
OL-26646-01
Figure
Loosen the captive thumbscrew screw that secures the rear edge of the cover to the chassis.
Push the cover toward the server rear about one-half inch (1.27 cm), until it stops.
Lift the cover straight up from the server and set it aside.
Place the cover on top of the server about one-half inch (1.27 cm) behind the lip of the front chassis
panel. The cover should sit flat.
The flanges on the top cover must slide underneath the front chassis panel.
Slide the top cover toward the front chassis panel, sliding the flanges on the top cover underneath
the front chassis panel.
Tighten the captive thumbscrew that secures the rear edge of the cover to the chassis.
Removing the Top Cover or Front Chassis Panel
2
3
3
Front panel lip
Front chassis panel
Front chassis panel securing screws
(two, one on each side of the panel)
3-3):
4
4
Top cover
5
Top cover thumbscrew
Cisco UCS C22 Server Installation and Service Guide
Preparing for Server Component Installation
5
3-7
Advertisement
Table of Contents
