Table of Contents
Advertisement
Embedded RAID Controller
Installing a Software Key Module for Embedded RAID 5 Support
The software RAID key module contains a chip on a small circuit board. This module attaches to a
motherboard header. This chip upgrades SAS support to add RAID 5 support (RAID 0, 1, 5, and 10 for
up to eight drives).
Note
You must have the SCU upgrade ROM module installed before you can use this module.
To install a RAID 5 software key module, follow these steps:
Locate the header (see
Step 1
Install the RAID 5 software key module onto the pins of the header.
Step 2
Replace the top cover.
Step 3
Replace the server in the rack, replace cables, and then power on the server by pressing the Power button.
Step 4
Enabling the Embedded RAID Controller in the BIOS
The embedded RAID controller uses different cables than the PCIe card controllers. See
Note
RAID Controllers and Required Cables, page C-2
The default setting in the BIOS for the embedded controller is Disabled. When you order the server with
Note
the embedded controller, the BIOS setting is Enabled at the factory. However, if a server is reset to
defaults, this BIOS setting is reverted to Disabled. Use the procedure below to re-enable the embedded
controller.
Use the following procedure to enable the LSI MegaSR drivers.
Boot the server and press F2 when prompted to enter the BIOS Setup utility.
Step 1
Select the Advanced tab, then South Bridge.
Step 2
Set Onboard SATA Controller to Enabled.
Step 3
Press F10 to save your changes and exit the utility.
Step 4
Cisco UCS C22 Server Installation and Service Guide
C-8
Figure
C-1).
Appendix C
and
RAID Controller Cabling, page
RAID Controller Considerations
Supported
C-17.
OL-26646-01
Advertisement
Table of Contents
