Replacing A Cisco Flexible Flash Card; Overview Of The Pre-Installed Cisco Flexible Flash Card - Cisco UCS C24 Installation And Service Manual
Hide thumbs
Also See for UCS C24:
- Installation and service manual (128 pages) ,
- Installation and service manual (100 pages)
Table of Contents
Advertisement
Chapter 3
Maintaining the Server
Replacing a Cisco Flexible Flash Card
This section includes the following topics:
•
•
•
•
•
•
Overview of the Pre-Installed Cisco Flexible Flash Card
The internal slots for these cards are on the circuit board of PCIe riser 2 (see
Note
Dual cards are supported only with CIMC 1.5(1) or later. With releases earlier than CIMC 1.5(1), only
a single card is supported and it must be in slot SD1.
The Cisco Flexible Flash card is pre-installed with three software bundles, each on one of four
preconfigured virtual drives (VDs). The fourth VD allows you to install an OS or embedded hypervisor.
The VDs are configured as follows:
1.
2.
3.
4.
Figure 3-36
1
OL-25761-01z
Overview of the Pre-Installed Cisco Flexible Flash Card, page 3-61
Booting a Cisco Flexible Flash Virtual Drive, page 3-62
Cisco UCS Server Configuration Utility (SCU).
Hypervisor (HV). This is a VD that you can use for your own purposes.
Cisco Drivers (Drivers).
Cisco Host Upgrade Utility (HUU).
Cisco Flexible Flash Card Slot Locations on PCIe Riser 2
FAN1
FAN4
FAN6
Slot SD2
Riser 1
SAS2
Riser 2
2
Slot SD1
Cisco UCS C240 Server Installation and Service Guide
Replacing a Cisco Flexible Flash Card
Figure
3-36).
1
2
3-61
Advertisement
Table of Contents
