Using The Cleaner - Hoover U8315960 Owner's Manual

Using the cleaner

DO NOT USE CLEANER OUTDOORS
OR ON DAMP OR WET SURFACES.
POWER button
The POWER button (A) is located
9
at the top of the cleaner body.
Plug cord into electrical outlet.
To turn cleaner ON, press button once.
To turn cleaner OFF, press button again.
NOTE: THE CLEANER IS SHIPPED
WITH THE CONTROL DIAL IN HARD
FLOOR POSITION. BEFORE YOU
BEGIN TO CLEAN CARPETS, ROTATE
THE CONTROL DIAL FROM HARD
FLOOR TO A CARPET SETTING.
Automatic agitator
brush roll shut-off
The agitator brush roll will turn off
12
when the handle is in the upright,
storage position.
Surface Command™
control dial (some models)
A
The Surface Command™ control
10
dial (some models) is an automat-
ic height adjustment that allows you to
choose a cleaning mode for carpet
height or hard surface floors.
For maximum cleaning performance,
the following carpet height settings are
recommended:
Lowest setting: for all types of carpet,
Note: If the cleaner is difficult to push,
turn dial to the next higher setting.
Higher settings: for very deep pile car-
pet where easier pushing effort is
desired, while maintaining good clean-
ing performance.
HARD FLOOR The agitator brush roll is
OFF; the nozzle is set at LOW.
Agitator brush roll control
B
OR
A
Rotate control dial to "Carpet"
13
settings (A) to turn agitator brush
roll ON for cleaning carpet or rugs.
Rotate control dial to "Hard Floor" (B) to
turn agitator brush roll OFF when clean-
ing hard floors.
Surface Selector (some
models)
The Surface Selector (some
11
models) has three carpet height
settings and a hard floor setting. The
Surface Selector turns to allow you to
choose a cleaning mode for carpet
height or hard surface floors.
For maximum cleaning performance, the
following carpet height settings are rec-
ommended:
Lowest setting: for all types of carpet,
Note: If the cleaner is difficult to push,
turn dial to the next higher setting.
Higher settings: for very deep pile car-
pet where easier pushing effort is
desired, while maintaining good clean-
ing performance.
HARD FLOOR MODE (with agitator
brush roll shut off) the nozzle is set at
LOW.
Cord rewind
A
A
Grasp the end of the plug and
14
pull to release cord from cord
B
reel. After desired cord length is reached,
the cord will lock into position.
07
(Cont'd)