Related Manuals for Hoover Savvy U8171
Summary of Contents for Hoover Savvy U8171
-
Page 1: Upright Vacuum Cleaner
Upright Vacuum Cleaner by HOOVER Owner’s Manual ENGLISH pp. 1-11 ESPAÑOL pág. 13-19 FRANÇAIS p. 21-31 Congratulations on your purchase! ® This product was designed for easy assembly (see page 3) www.hoover.com... -
Page 2: Table Of Contents
• Do not use with damaged cord or plug. If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, take it to a Hoover Factory Service Center or Authorized Hoover Warranty Service Dealer (Depot). -
Page 3: Assembling Cleaner
If you need any assistance: Visit our website at www.hoover.com. Click on the “Service” button to find the service outlet nearest you OR Call 1-800-944-9200 for an automated referral of service outlet locations (U.S. only) Call 1-330-499-9499 to speak with a representative in our Consumer Response Center. -
Page 4: Cleaner Descriptions
Remove label (C) from Custom Push screws into holes on back of Place hose on holder. Control™ switch. handle (Fig. 1-6) and hose holder (Fig. 1-7). If label has come off during assembly, make sure switch is in Tighten screws securely with a OFF (down) position before plug- Phillips screwdriver. -
Page 5: Carpet Height Adjustment
Transporting cleaner Handle positions Carrying cleaner Put handle in upright position. Tilt clean- Use the carrying handle to lift the The handle of your cleaner has three er back on rear wheels. Push forward. positions; upright for storage and when cleaner. -
Page 6: Cleaning Tools
Cleaning tools 2-12 2-13 When using cleaning tools, cleaner han- dle should be in the upright position to activate the automatic “brush roll OFF” and for convenience in moving the cleaner from one area to another. 2-11 Select proper tool Attach wand and tools F. -
Page 7: Cleaning Filter
HOOVER filter bags distributed tively. by The Hoover Company to assure that NOTE: All new carpet has loose fibers your cleaner operates at peak perfor- which can fill the bag quickly while mance. -
Page 8: Replacing Edge Groomers
Headlight replacement What to buy This cleaner uses a 12 volt, wedge base type 912 bulb, HOOVER part No. 27313107. Install bulb - Replace lens - Pull old bulb straight Place one tab (F) on out of socket. Push new bulb straight lens into slot. -
Page 9: Agitator Brush Roll
Agitator brush roll replacement When agitator brush roll brushes are worn, the brush roll should be replaced. Ask for HOOVER part No. 48414088. 3-15 3. Remove agitator including end plates 2. Unscrew the two Phillips screws and (C) and discard. -
Page 10: If You Have A Problem
(see pg. 10). Hoover Cleaning • Filter bag full Performance • Change filter bag. This Hoover Cleaning Performance Sys- • Incorrect carpet height setting tem is for comparing the relative pro- • Move nozzle control knob to lower gressive performance of Hoover setting. -
Page 11: Clearing Blockages
Hoover Company on-line at rights which vary from state to state www.hoover.com (or province). Do not send your cleaner to The Hoover If further assistance is needed, or if Company in North Canton for service, there are questions concerning this this will only result in delay.