How To Display Faults; How To Bypass Zones - Honeywell 6280 Series User Manual

How to Display Faults

The Display Faults function is used when you see a "Not Ready Fault" message and want to determine where the
fault is and what type of fault it is. To display faults do the following:
ICON
1. From the "Security" screen, touch the
Display Faults icon.
2. If the fault cannot be corrected, you may
choose to bypass a zone by touching the zone
to highlight it and then touching the Bypass
Selected icon.
Show Zones Icons
Refresh
Clear
Bypass
Data
Bypasses
Selected

How to Bypass Zones

The Bypass function is used when you want to arm your system with one or more zones left open. Bypassed zones
are unprotected and do not cause an alarm when violated while your system is armed.
• Residential systems do not allow you to bypass fire, carbon monoxide or emergency zones. On commercial fire systems, a
specified user may be allowed to bypass fire, carbon monoxide and system zones if the user was enabled by your system
installer.
• Limits apply as to how many zones can be bypassed at one time. These limits are ten zones on residential systems and
five zones on commercial systems.
To bypass zones do the following:
ICON ACTION
1. Touch the SECURITY icon.
2. Touch the MORE CHOICES icon.
Security (cont'd)
ACTION
A listing of faulted and/or bypassed zones is displayed.
As applicable, take corrective action such as closing a window or door to
correct the fault.
Distressed Zone Icons
Bypass All Distressed
Zones
Note: If any zones are bypassed or faulted, a Display Faults icon is also
displayed on this screen.
12
NOTES
Alarm Troubles
Faults
NOTES
Low
Bypass
ALL
Battery
Zones