Security; Introduction To Security System Operation - Honeywell 6280 Series User Manual

Touchcenter
Hide thumbs Also See for 6280 Series:
Table of Contents

Advertisement

Introduction to Security System Operation

You can arm your system in one of three arming modes: Away, Stay, and Night. The following table lists the three
different arming modes and the results of each.
Arming
Mode
AWAY
Press to arm when no one is staying on the premises.
When armed in AWAY, the system sounds an alarm if
a protected door or window is opened, or if any
movement is detected inside the premises.
STAY
Press to arm when you are staying home, but might
expect someone to use the entrance door later.
When armed in STAY, the system sounds an alarm if
a protected door or window is opened, but you may
otherwise move freely throughout the premises.
NIGHT
Press to arm when you are staying home and do not
expect anyone to use the entrance door. Your installer
may have configured NIGHT Mode differently; have
the installer describe the actual settings of this mode.
Note: Night Mode (on Residential Panels Only) arms all perimeter zones plus all zones listed in Zone List 5.
IMPORTANT: On commercial systems, "Away Auto Stay" mode is shown as "Away" mode (with all zones monitored). However, some
interior zones may not be armed.
Note: The Voice Status Icon (
3 seconds and press again to hear Zone Faults or Trouble conditions. Voice status will annunciate even if Voice mode and Chime
mode are disabled. Note that the Voice feature must be enabled (by the installer) for this icon to function correctly during an alarm
condition.
Note: There is a communicator delay of 30 seconds. This delay will prevent a report to the central station if the control panel is
disarmed within 30 seconds after an intrusion alarm is triggered. This delay can be removed, or it can be increased up to 45 seconds at
the option of the user by consulting with the installer. Note that fire-type alarms are normally reported without delay.

Security

FEATURES FOR EACH ARMING MODE
FUNCTION
) indicates the TouchCenter Voice feature. Press the Voice Status Icon to hear system status. Wait
10
Entry
Exit
Delay
Delay
Yes
Yes
Yes
Yes
Yes (set for Away or
Yes
Stay Mode)
No (set for Instant or
Maximum Mode)
Perimeter
Interior
Armed
Armed
Yes
Yes
Yes
No
Yes
Yes
(set for Away or
Maximum Mode)
No (set for Stay or
Instant Mode)
See note below for
Night Mode arming.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Touchcenter 6280 series

Table of Contents