Security; Introduction To Security System Operation - Honeywell 6280 Series User Manual

Security

Introduction to Security System Operation

You can arm your system in one of three arming modes: Away, Stay, and Night. The following table lists the three
different arming modes and the results of each.
Arming
Mode
AWAY
Press to arm when no one is staying on the premises.
When armed in AWAY, the system sounds an alarm if
a protected door or window is opened, or if any
movement is detected inside the premises.
STAY Press to arm when you are staying home, but might
expect someone to use the entrance door later.
When armed in STAY, the system sounds an alarm if
a protected door or window is opened, but you may
otherwise move freely throughout the premises.
NIGHT
Press to arm when you are staying home and do not
expect anyone to use the entrance door. Your installer
may have configured NIGHT Mode differently; have
the installer describe the actual settings of this mode.
Note: The Voice Status Icon (
announce system status if pressed at least 10 seconds following its last press. Note that the Voice feature must be
enabled (by the installer) for this
FEATURES FOR EACH ARMING MODE
FUNCTION
) indicates the TouchCenter Voice feature. This
to function correctly during an alarm condition.
icon
10
Exit Entry
Delay
Delay
Yes Yes
Yes Yes
Yes (set for Away or
Yes
Stay Mode)
No (set for Instant or
Maximum Mode)
icon
Perimeter Interior
Armed Armed
Yes Yes
Yes No
Yes Yes
(set for Away or
Maximum Mode)
No (set for Stay or
Instant Mode)
causes the TouchCenter to