Yamaha XVS13AWC Service Manual page 86

1. Rear cylinder thermostat inlet hose
2. Right handlebar switch lead
3. Wire harness
4. Front cylinder resonator hose
5. Front cylinder intake air pressure sensor hose
6. Canister purge hose (California only)
7. Throttle position sensor
8. Rear cylinder intake air pressure sensor hose
9. Rear cylinder resonator hose
10. Sub-wire harness couplers
11. Fuel hose
12. Injectors
13. Front cylinder thermostat inlet hose
14. Rear cylinder intake air pressure sensor
15. Front cylinder intake air pressure sensor
A. Face the ends of the hose clamp inward.
B. Face the ends of the hose clamp outward.
C. Align the hose clamp with the white paint mark on
the canister purge hose (California only) and face
the ends of the clamp forward.
D. Route the canister purge hose (California only) to
the outside of the front cylinder resonator hose,
and then install it onto the throttle body pipe up to
the bend in the pipe, making sure to face the white
paint mark on the hose upward.
– –
E. 2 4 mm (0.08 0.16 in)
F. Route the canister purge hose (California only)
under the front cylinder intake air pressure sensor
hose and rear cylinder intake air pressure sensor
hose.
G. Fasten the sub-wire harness at the white tape with
a plastic locking tie.
H. Face the ends of the hose clamp rearward.
I. Face the ends of the hose clamp forward.
J. Install the front cylinder intake air pressure sensor
hose with its white paint mark facing outward.
K. Install the rear cylinder intake air pressure sensor
hose with its yellow paint mark facing outward.
– –
L. 0 1 mm (0 0.04 in)
2-60
CABLE ROUTING