Yamaha XVS13AWC Service Manual page 15

NOTE:
Push the " " side of the "SELECT" switch to
switch the display in the reverse order.
To reset a tripmeter, select it by pushing the "
or " " side of the "SELECT" switch, and then
push the "RESET" switch for at least one sec-
ond. If you do not reset the fuel reserve tripmeter
manually, it will reset itself automatically, and the
display will return to the prior mode after refuel-
ing and traveling 5 km (3 mi).
Clock mode
1
1. Clock
Push the "RESET" switch for less than one sec-
ond to display the clock for five seconds, regard-
less of the currently selected display mode.
To set the clock:
1. Push the " " or " " side of the "SELECT"
switch to change the display to the clock
mode.
2. Push the " " side of the "SELECT" switch
and the "RESET" switch together for at least
two seconds.
3. When the hour digits start flashing, push the
" " or " " side of the "SELECT" switch to
set the hours.
4. Push the "RESET" switch, and the minute
digits will start flashing.
5. Push the " " or " " side of the "SELECT"
switch to set the minutes.
6. Push the "RESET" switch and then release it
to start the clock.
Self-diagnosis device
This model is equipped with a self-diagnosis de-
vice for various electrical circuits.
If any of those circuits are defective, the engine
trouble warning light will come on, and then the
odometer/tripmeter/clock display will indicate a
two-digit error code (e.g., 12, 13, 14).
If the odometer/tripmeter/clock display indicates
any error codes, note the code number, and
then check the vehicle. Refer to "FUEL INJEC-
TION SYSTEM" on page 8-31.
"
ECA3D81016
CAUTION:
If the display indicates an error code, the ve-
hicle should be checked as soon as possible
in order to avoid engine damage.
Brightness control mode
1
1. Speedometer panel
2. Brightness level
This function allows you to adjust the brightness
of the speedometer panel to suit the outside
lighting conditions.
To set the brightness:
1. Turn the key to "OFF".
2. Push and hold the "
switch.
3. Turn the key to "ON", and then release the
"SELECT" switch after five seconds or more.
4. Push the " " or "
switch to select the desired brightness level.
5. Push the "RESET" switch to confirm the se-
lected brightness level. The display will return
to the odometer, tripmeter or clock mode.
1-5
FEATURES
2
" side of the "SELECT"
" side of the "SELECT"