Error Messages - Denon AVR-1909 Owner's Manual

( Step 5 : Store
• Menu screen •
CD
[J"Store~
Cancel~
The auto setup measurement results are stored in the AVR-1909.
CD
Press 6. to select" Store ...... then press
• "Storing Please wait··· .. is displayed on the on-screen display
while the results are being stored.
• When storing is complete, "Storing complete. Auto Setup is now
finished." is displayed on the on-screen display.
en
Select" Exit". then press ENTER.
®
Disconnect the setup microphone from the AVR-1909.
o
To cancel storing
Press 6. \l to select "Cancel ...... then press
• All the measured auto setup data will be erased.
_Ntn.
Do not turn the power off while the settings are being stored.
)

Error Messages

If the auto setup procedure could not be completed due to speaker installation, the measuring environment. etc., an error message is
displayed. If this happens, check the relevant items, be sure to take the necessary measures,then perform the auto setup procedure over
again.
Error messages (examples)
<3.
Ret r y
Cancel~
<3.
Auto Setup
Auto Setup
~~=
'I
~
§
:ft.:.
Select" Retry" to measure again.
-Ntii.
Be sure to turn the power off before checking the speaker connections.
Cause
• Included setup microphone is not connected. • Connect the included setup microphone to the
• Not all speakers could be detected.
• The front L speaker was
detected.
• Too much noise in the room for
measurements to be made.
• Speaker or subwoofer sound is too
accurate measurements to be made.
~
• Displayed speaker could not be detected.
. The front R speaker were not properly
AudweL
Mu I t EQ detected.
t4.'~"'.
Only one channel of the surround speakers
-i..
Fro n t
[J"~
was detected.
Sound was output from the R channel
O l ,I4
when only one surround back speaker was
Retry~
connected.
Cancel~
. The surround back. but the surround speaker
was not detected.
• Displayed speaker
?\
polarities reversed.
AudW Mu I t EQ
!!i!!!!i!A·U
Fro n t
[J' ~
Ret r y ~
Cancel~
Ski ~
MIC
jack on the main unit.
• Check the speaker connections.
properly
not
accurate • Either turn off any device generating noise or move it
away.
• Try again when the surroundings are quieter.
low for • Check the speaker installation and the direction in
which the speakers are facing.
• Adjust the subwoofer's volume.
• Check the connections of the displayed speaker.
connected with the • Check the polarities of the displayed speaker.
• For some speakers. this error message may be
displayed even if the speaker is properly connected. If
you are sure that the wiring is correct, select" Skip".
ENGLISH
Measures
SETUP
I
28