Denon AVR-1909 Owner's Manual page 30

ENGLISH
C'-S_t_e.:..p_2_:_M_e_as_u_r_e_rn_e_n_t
• Menu screen •
m
[J'Next4
Calculate4
I
Cancel4
(J"Next4
Calculate4
Ret r y 4
Cancel4
G) Press 6. to select "Next "''', then press
• The measurement of the 2nd position starts.
o
Move the microphone to the 3rd position and press
• The measurement of the 3rd position starts.
® 0
Perform repeatedly for the 4th, 5th, and 6th measurments.
• "All the measurements were finished." is displayed on the on-
screen display. When you have completed measurements in 6
positions
• If you want to stop after measuring just five or fewer positions,
press \l to select "Cancel"''', then press
After completing a measurement position, move the microphone to
the next position.
Measure at 6 positions: the main listening position and 5 other
surrounding positions. Although it is allowable to measure less than 6
positions, it is recommended to measure 6 for best results.
27
(Step 3 : Calculation
)
J
• Menu screen •
...
....
[J'Calculate4
,
Ret r y 4
Cancel4
[J'Ca nee I 4
The values obtained from the measurements are automatically
analyzed and the attributes for each of the speakers in the listening
area are determined.
G) Press 6. to select "Calculate "''', then press
• Analysis begins.
• Analysis takes several minutes to complete.
• The time required for this analysis depends on the number of
<l.
speakers connected. The greater the number of speakers connected,
the longer analysis will take.
<l
-N'U8
• Do not change the speaker connections or subwoofer volume,
or speaker locations after making measurements. If changes are
necessary, make the changes and use the Audyssey MultEO auto
setup once again for an updated EO solution.
• For instance, if the location or direction of a speaker is altered, the
<l.
Auto Setup should be performed again to ensure the correct EO
solution for the new room configuration.
m
..
_---------._
~ _
<l.
) (Step 4 : Check
• Menu screen •
m
[J'Speaker Config. Check
Distance Check
Channel Level Check
Crossover FreQ. Check
Next4
When analysis is complete, check the analysis results for the following
four items.
G) Make your selection using \l and press
Lc,.
• Presence and size of speaker
"Speaker Config. Check"
• Distance of speaker from listening position
"Distance Check"
• Speaker channel level
"Channel Level Check"
• Crossover Frequency
"Crossover Freq. Check"
(1) Use 6. \l to change which speaker is displayed.
OTo switch to another analysis result item
RETURN
Press
This returns you to analysis results items, so repeat step G).
OTo proceed to "Step 5: Store"
Press 6. to select "Next "''', then press
Distance values that are greater than the actual distance of a speaker
may be accurate for speakers with built-in filters (subwoofers, etc).
This is because these filters add electrical delay (distance) to the signal
that is compensated for by the Auto Setup process.
)
ENTER.
<l.